Every spring brings the time: time to open the above ground pool for summer swimming season. It 'been a hard, cold winter, and it seems so long ago that the pool was open and the water was brilliant. This step-by-step instructions you received your above ground swimming pool open and running in practically no time.
1 begin to suck all the water that could be collected on top of your pool cover. If you plan to use an electric pump to suck, it's a good idea to put a plastic Frisbeeor similar object between the cover and the pump.
2 Carefully remove all leaves and other debris from the top of the lid.
3 Disconnect and remove the cable cover from the key.
4 Remove all the clips cover and water pipes.
5 Take the lid slowly. Make sure that no debris fell on top of the cover into the pool when you can slide the cover.
6 Remove the cushion by lifting the cable. The air from the pillow.
7 Remove all sticks and leaves orother articles of the pool skimmer or leaf with a network.
8 We wait for the water level is too low. This is done by moving ice, and water evaporation.
9 The water level is likely to be insignificant. Add more. It 'important that the water level halfway up the skimmer. It is recommended to maintain this level of water during the bathing season.
10 Check your skimmer, pump and filter to ensure that they are in perfect condition.
11 Install the pump on the base. Fixwith two mounting screws of the pump.
12 Connect the ground wire to the pump.
13 Replace the filter on the base.
14 Ensure that all the rubber O-rings are lubricated and in good condition.
15 Close the connection between the pump and filter.
16 Connect the hose from the pump filter in the skimmer.
17 If you are using a chlorine plant, put the return hose from the chlorine filter. Then connect the return pipe of theOutlet.
18 Remember to secure all clamps.
19 Ensure that the cover is securely fastened to the lid of the pump.
20 Use the removal tool to remove the plug from the return of winter meeting. Then take the door or water-ice plate from the skimmer.
21 Ensure that all screws are securely connected to the skimmer.
22 Attach the back piece eyeball. Make sure that the installation of all parts are assembled before installing. Once installed, be sure to add the pointInstallation in a downward angle.
23 Reinstall the skimmer basket and skimmer dam.
24 If you have a bridge, install the head in the flanges on the cover of the surface. If you do not have a deck around your pool or against, install the A-frame ladder. If you are going to drop-in steps, sand bags first place in Group stairs, then use the stairs into the water. Place the handrail in the flange of the deck or stairs.
25 Ensure that any electrical connection is madegrounded.
26 Turn off the filtration system.
27 If you have a DE filter, insert the required amount of DE. Expect to "bump" your filter several times during the first 24 hours.
28 When using a cartridge, you must install the filter cartridge.
29 If you have a sand filter, make sure the drain plug in the tank. Be sure to fill out, fix the filter with a sand filter. You must replace the sand filter at least every two years.
30Backwash filter.
Connect the pump 31.
32 It marks the turning point of the valve handle to "filter" and turn on the pump.
33 Do not empty the pool for at least 24 hours.
That's all. Now you can swim in the pool. Have fun in the water.
